Plain English
What P0300 means for your Ford Explorer
Your Camry's ECM detected that cylinder 1 isn't firing properly - the crankshaft position sensor saw the rotational speed dip slightly each time cylinder 1 was supposed to combust. On the 2.5L 2AR-FE and earlier 2AZ-FE, this almost always traces back to a tired ignition coil. Toyota's coils are durable but they have a typical service life of 80k-130k miles, and once one starts to break down it usually shows up as P0300 (or P0302/P0303/P0304) under load. The cylinder-1 coil sits at the front of the engine and runs slightly hotter than the rear coils, which is why it tends to fail first.
🎯 Top Causes on the Ford Explorer
30%
#1 MOST LIKELY
EcoBoost Timing Chain Stretch (3.5L)
2011-2016 3.5L EcoBoost Explorers stretch timing chains at 100k. Throws cam timing, multi-cyl misfires, P0300 + P0008/P0016. Major repair.
PART
🎯 Top Causes on the Ford Explorer
,000–60%
#1 CAUSE
Failing Cylinder 1 Ignition Coil
Toyota uses coil-on-plug (COP) ignition - one coil per cylinder bolted directly above the spark plug. After 80k-130k miles the secondary windings in the cylinder-1 coil break down and the spark gets weak under load. Easy diagnostic trick: swap the cylinder 1 coil with the cylinder 3 coil and clear the code. If the misfire moves to P0303, the coil is the problem. Denso and NGK make Toyota OEM-equivalent coils for around $50-$80 each. Replace all four coils as a set if mileage is high - they all age together.
OEM Coil
$80-$120
Aftermarket
$45-$70
w/Labor
$120-$280
25%
#2 CAUSE
Worn Spark Plug on Cylinder 1
The Camry's iridium plugs are spec'd for 100k miles but they wear early if oil consumption is present (especially on 2007-2009 2AZ-FE engines, which have a known oil-burning issue). A worn plug raises the firing voltage demand and overstresses the coil. Check the cylinder-1 plug for excessive gap, oil fouling, or a worn electrode. Use only Denso or NGK iridium plugs - cheap copper plugs cause repeat misfires within months on this engine.
Plugs (set 4)
$30-$60
V6 Plugs (6)
$45-$90
w/Labor
$80-$220
15%
#3 CAUSE
Fuel Injector Clog or Leak
If the cylinder-1 injector is partially clogged or leaking, the air-fuel ratio in that cylinder is wrong and you get a single-cylinder misfire that swaps when you swap injectors. Less common than coil/plug but worth checking after the easy stuff. Pull the injectors and have them flow-tested at a shop, or just replace the cylinder-1 injector with a known-good unit to confirm.
Injector
$60-$140
Flow Test
$80-$150
w/Labor
$150-$320
LABOR
🎯 Top Causes on the Ford Explorer
,500–DIY
Hard
25%
#2 COMMON
EcoBoost Carbon Buildup
GDI engines build carbon on intake valves at 60k-100k, causing multi-cyl misfires. Walnut blast required.
PART
60%
#1 CAUSE
Failing Cylinder 1 Ignition Coil
Toyota uses coil-on-plug (COP) ignition - one coil per cylinder bolted directly above the spark plug. After 80k-130k miles the secondary windings in the cylinder-1 coil break down and the spark gets weak under load. Easy diagnostic trick: swap the cylinder 1 coil with the cylinder 3 coil and clear the code. If the misfire moves to P0303, the coil is the problem. Denso and NGK make Toyota OEM-equivalent coils for around $50-$80 each. Replace all four coils as a set if mileage is high - they all age together.
OEM Coil
$80-$120
Aftermarket
$45-$70
w/Labor
$120-$280
25%
#2 CAUSE
Worn Spark Plug on Cylinder 1
The Camry's iridium plugs are spec'd for 100k miles but they wear early if oil consumption is present (especially on 2007-2009 2AZ-FE engines, which have a known oil-burning issue). A worn plug raises the firing voltage demand and overstresses the coil. Check the cylinder-1 plug for excessive gap, oil fouling, or a worn electrode. Use only Denso or NGK iridium plugs - cheap copper plugs cause repeat misfires within months on this engine.
Plugs (set 4)
$30-$60
V6 Plugs (6)
$45-$90
w/Labor
$80-$220
15%
#3 CAUSE
Fuel Injector Clog or Leak
If the cylinder-1 injector is partially clogged or leaking, the air-fuel ratio in that cylinder is wrong and you get a single-cylinder misfire that swaps when you swap injectors. Less common than coil/plug but worth checking after the easy stuff. Pull the injectors and have them flow-tested at a shop, or just replace the cylinder-1 injector with a known-good unit to confirm.
Injector
$60-$140
Flow Test
$80-$150
w/Labor
$150-$320
LABOR
$400–$800
DIY
Hard
20%
#3 POSSIBLE
Aged Ignition Coils
Explorer coils fail in clusters at 90k-120k. Replace all 6 (V6) as a set.
PART
60%
#1 CAUSE
Failing Cylinder 1 Ignition Coil
Toyota uses coil-on-plug (COP) ignition - one coil per cylinder bolted directly above the spark plug. After 80k-130k miles the secondary windings in the cylinder-1 coil break down and the spark gets weak under load. Easy diagnostic trick: swap the cylinder 1 coil with the cylinder 3 coil and clear the code. If the misfire moves to P0303, the coil is the problem. Denso and NGK make Toyota OEM-equivalent coils for around $50-$80 each. Replace all four coils as a set if mileage is high - they all age together.
OEM Coil
$80-$120
Aftermarket
$45-$70
w/Labor
$120-$280
25%
#2 CAUSE
Worn Spark Plug on Cylinder 1
The Camry's iridium plugs are spec'd for 100k miles but they wear early if oil consumption is present (especially on 2007-2009 2AZ-FE engines, which have a known oil-burning issue). A worn plug raises the firing voltage demand and overstresses the coil. Check the cylinder-1 plug for excessive gap, oil fouling, or a worn electrode. Use only Denso or NGK iridium plugs - cheap copper plugs cause repeat misfires within months on this engine.
Plugs (set 4)
$30-$60
V6 Plugs (6)
$45-$90
w/Labor
$80-$220
15%
#3 CAUSE
Fuel Injector Clog or Leak
If the cylinder-1 injector is partially clogged or leaking, the air-fuel ratio in that cylinder is wrong and you get a single-cylinder misfire that swaps when you swap injectors. Less common than coil/plug but worth checking after the easy stuff. Pull the injectors and have them flow-tested at a shop, or just replace the cylinder-1 injector with a known-good unit to confirm.
Injector
$60-$140
Flow Test
$80-$150
w/Labor
$150-$320
LABOR
🎯 Top Causes on the Ford Explorer
00–60%
#1 CAUSE
Failing Cylinder 1 Ignition Coil
Toyota uses coil-on-plug (COP) ignition - one coil per cylinder bolted directly above the spark plug. After 80k-130k miles the secondary windings in the cylinder-1 coil break down and the spark gets weak under load. Easy diagnostic trick: swap the cylinder 1 coil with the cylinder 3 coil and clear the code. If the misfire moves to P0303, the coil is the problem. Denso and NGK make Toyota OEM-equivalent coils for around $50-$80 each. Replace all four coils as a set if mileage is high - they all age together.
OEM Coil
$80-$120
Aftermarket
$45-$70
w/Labor
$120-$280
25%
#2 CAUSE
Worn Spark Plug on Cylinder 1
The Camry's iridium plugs are spec'd for 100k miles but they wear early if oil consumption is present (especially on 2007-2009 2AZ-FE engines, which have a known oil-burning issue). A worn plug raises the firing voltage demand and overstresses the coil. Check the cylinder-1 plug for excessive gap, oil fouling, or a worn electrode. Use only Denso or NGK iridium plugs - cheap copper plugs cause repeat misfires within months on this engine.
Plugs (set 4)
$30-$60
V6 Plugs (6)
$45-$90
w/Labor
$80-$220
15%
#3 CAUSE
Fuel Injector Clog or Leak
If the cylinder-1 injector is partially clogged or leaking, the air-fuel ratio in that cylinder is wrong and you get a single-cylinder misfire that swaps when you swap injectors. Less common than coil/plug but worth checking after the easy stuff. Pull the injectors and have them flow-tested at a shop, or just replace the cylinder-1 injector with a known-good unit to confirm.
Injector
$60-$140
Flow Test
$80-$150
w/Labor
$150-$320
DIY
Easy
15%
#4 POSSIBLE
Cracked Exhaust Manifold (3.5L Cyclone)
2011-2019 Cyclone V6 cracks exhaust manifolds → lean condition + multi-cyl misfires. Listen for cold-start tick.
PART
🎯 Top Causes on the Ford Explorer
50–$500LABOR
00–$800
DIY
Hard
10%
#5 POSSIBLE
Worn Spark Plugs
Cyclone plugs spec 100k, EcoBoost 60k. Overdue plugs cause clusters of misfires.
PART
$40–
🎯 Top Causes on the Ford Explorer
60LABOR
🎯 Top Causes on the Ford Explorer
00–DIY
Medium
🚗 Most Affected Camry Model Years
| Year | Engine | Primary Cause | Typical Mileage | Notes |
|---|---|---|---|---|
| 2010-2017 | 2.5L 2AR-FE | Coil pack | 80k-130k | Most common P0300 reports |
| 2007-2009 | 2.4L 2AZ-FE | Coil + oil-fouled plug | 90k-160k | Oil consumption shortens plug life |
| 2018+ | 2.5L A25A-FKS | Coil pack | 60k-90k | Newer engine, fewer reports so far |
| 2007-2017 | 3.5L 2GR-FE V6 | Rear-bank coils | 80k-130k | Rear coils harder to access |
🔧 How to Diagnose P0300 on a Ford Explorer
- Swap the cylinder 1 ignition coil with cylinder 3. Each coil is held by a single 10mm bolt and an electrical connector. Move the coil-1 to position 3 and the coil-3 to position 1, clear the code, and drive 5-10 minutes. If the misfire follows the coil to cylinder 3 (you'll see P0303), replace the original cylinder-1 coil. This 15-minute test confirms the coil 9 times out of 10 on a Camry.
- Check the spark plug. Pull the cylinder-1 plug and inspect: black sooty deposits = rich/coil; oil-wet = oil consumption (common on 2AZ-FE); white/blistered = lean. Gap should be 0.043" on most Camrys. Replace all four plugs as a set if mileage is over 80k - mixing new and old plugs causes more misfires.
- Read live data with a scanner. Look at fuel trims and the misfire counter per cylinder. If only cylinder 1 is misfiring AND fuel trims are normal, focus on ignition (coil/plug). If cylinder 1 misfires AND fuel trims are skewed, suspect injector or compression. A compression test (should be 170-220 psi on 2AR-FE) rules out a bigger mechanical issue.
Want a step-by-step walkthrough specific to your Ford Explorer? Run a $5.99 AI diagnosis report - we narrow the cause to your year, engine, and symptoms.