P2319Ignition System
Ignition Coil G Primary Control Circuit High
P2319 means the ECM detected high voltage on the primary control circuit for ignition coil G, indicating the coil is not switching correctly.
🚗 Not recommended. A misfiring cylinder can damage the catalytic converter.
Is P2319 really the problem on YOUR car?Get a free AI diagnosis ranked by probability for your exact year, make, and model.
Run Free Diagnosis →
🎯 Top Causes, Ranked by Likelihood
#1Failed ignition coil (cylinder G)$30-$120
Open or shorted primary circuit in the coil.
#2Open or shorted coil wiring$40-$250
Break in the control wire or a short to power.
#3ECM driver circuit fault$200-$900
Failed coil driver inside the ECM.
🩺 Common Symptoms
- Single cylinder misfire
- Rough idle
- Check engine light
- Hesitation under load
- Reduced power
💰 Repair Cost: DIY vs Shop
📋 Free OBD2 Code Cheat Sheet
The 50 most common codes with likely cause and DIY fix cost. Sent once, no spam.
🔧 How to Diagnose P2319
1Identify the cylinder for coil G on your engine
2Swap the coil to a nearby cylinder to see if the code moves
3Check the wiring for a short to power or an open
4Replace the coil if it is at fault
❓ Frequently Asked Questions
Can I drive with P2319?
Only briefly. The dead cylinder wastes fuel and risks catalytic converter damage.
What is the difference between P2318 and P2319?
P2318 is a low-voltage fault and P2319 is a high-voltage fault on the same coil G primary circuit.
How much does P2319 cost to fix?
About $30-$150 DIY or $120-$400 at a shop.
🔗 Related Codes
Don't guess. Know exactly what's wrong.AmpAuto's AI ranks the real causes for your specific vehicle in 30 seconds.
Diagnose P2319 Free →