P0370 means timing reference high resolution signal a. The ECM saw a value or response outside its calibrated window for the ignition system. Real-world fixes usually start with the highest-probability cause below for your year, make, and model - not a parts-cannon guess.
Should you drive?
Severity HUD
HIGHSEVERITY
Is P0370 the real problem on YOUR car?Free AI ranking by year, make, and model - 30 seconds.
Misfire energy drops and the monitor flags the cylinder or circuit.
#2Crank/cam sensor or reluctor issue$80-$400
0%
Timing reference is noisy, missing, or out of correlation.
#3Wiring or connector fault$50-$220
0%
Intermittent opens cause no-start or random misfire.
#4ECM knock or ignition driver fault$100-$600
0%
Module-side driver or knock control logic fails the monitor.
Symptoms Radar
Check engine light on (or flashing if misfire-related)
Reduced power, limp mode, or hard starting
Failed emissions readiness or inspection risk
Intermittent stumble under load
Related codes stored with freeze-frame data
Repair Cost
DIY
$80-$450
Shop
$250-$1800
Diagnose It
1Confirm P0370 is current (not history-only) and save freeze-frame RPM, load, and fuel trim.
2Inspect connectors and harness for the listed sensor/actuator before replacing parts.
3Command the actuator or graph the sensor live with a scan tool; compare to known-good values.
4Fix the root cause, clear codes, and verify monitors complete on a mixed drive cycle.
FAQ
Can I drive with a P0370 code?
Park it if power is cut, shifting is violent, or the light is flashing - short trips only if it still drives normally.
How much does it cost to fix P0370?
DIY parts typically land around $80-$450. A shop diagnosis plus repair commonly runs $250-$1800, depending on whether it is a sensor, harness, or major component.
What is the most common cause of P0370?
Failing coil, plug, or wire is the most common starting point (~40%), followed by crank/cam sensor or reluctor issue.