C0561ABS / Stability

System Disabled Information Stored

C0561 means the ABS or stability control system has been disabled and the module stored that information. It is usually a companion code set because another fault, often a lost signal on the data bus or a wheel speed issue, told the system to shut down.

🚗 Yes, but ABS or stability control has been disabled by another fault, so scan for the underlying code.

MEDIUM

severity

🎯 Top Causes, Ranked by Likelihood

#1Another active ABS/stability fault$0-$500

45%

A separate code (sensor, module, bus) triggered the shutdown.

#2Communication (CAN bus) fault$50-$400

25%

Lost data from steering, yaw, or ECM disables the system.

#3Low system voltage$100-$300

20%

Weak battery or charging trips a system-disable state.

#4Calibration or setup needed$0-$150

10%

Steering or yaw sensor needs recalibration after service.

🩺 Common Symptoms

ABS warning light on
Traction and stability control lights on
Feature warning message on the dash
Other stored DTCs alongside this one

💰 Repair Cost: DIY vs Shop

DIY Cost

$0-$400

Shop Cost

$100-$600

📋 Free OBD2 Code Cheat Sheet

The 50 most common codes with likely cause and DIY fix cost. Sent once, no spam.

🔧 How to Diagnose C0561

1Scan for all stored codes, not just C0561

2Diagnose and repair the other active codes first

3Check battery voltage and module communication

4Clear codes and recheck after fixing the root cause

❓ Frequently Asked Questions

Can I drive with C0561?

Yes, base braking works, but ABS or stability control is disabled by another fault. Scan for the root code and fix it.

How much to fix C0561?

It depends entirely on the underlying fault, from a cheap sensor to a module repair.

What causes C0561 most often?

Another active ABS or stability control fault, a communication issue, or low voltage that disabled the system.

🔗 Related Codes

C0035C0161C0710C0800